Descaler (2 Pack, 2 Uses Per Bottle) – Made in the USA – Universal Descaling Solution for Keurig, Nespresso, Delonghi and All Single Use Coffee and Espresso Machines

Instead, follow the Keurig instructions or else you’ll never clear the “Descale” light or warning text. I’ve seen some reviews where people complained that their descaling light/warning didn’t go away. Well, it won’t until you run the specific descale cycle required by your machine. On the website, the video is more accurate than the text for my model.

Supposedly this is more concentrated than the Keurig solution, so you use half a bottle (4 oz). The descale function on my machine is expecting 16 ounces of liquid (8 oz descaler with the official solution +8 oz water) , so that’s what I did, pouring half this bottle and then adding a little over 12 oz water to perform the descaling cycle, which starts out from power off and then pressing specific buttons to start it. And then once it’s done that first step, it takes a full two reservoirs running cycles over and over to rinse out the machine following the descaling. And then it says add water a second time and the warning on my screen goes away.

After three attempts at descaling using three different YT videos, reading different comments on “how to.” I found one that gave exact instructions. It would have been nice if they were included in the solution package! If you’re thinking I’m a moron, I will take that. I was just determined to get the descaling light to go off before I used a sharpie to color it in or throw my Keurig in the trash. Trust me, both crossed my mind!
HOW TO/COMMENTS:
1. If the descaling solution bottle is meant for two uses, they could just put a mark on the label so you don’t have to eye ball it, or pay that much attention to what “half” is. Yes, I’m OCD!
2. The 3rd video I watched, during my third attempt, had that you press both the 8 oz & 12 oz buttons when the power is OFF! That sets it in “Descale Mode” ((One instruction had 8/10, and no one else was clear about pushing the buttons when it was “OFF.”))
3. They also said you put half of the descaling solution into the reservoir then just add enough water until the “add water” light goes off. Make sure you have a bowl or large mug to catch the solution when it comes through the machine. When the add water light goes out, and the “K” comes on, you just have to press the K, and it will start running the solution through your machine. Keep hitting the K, until the “add water” light comes on again. Dump the solution water out.
4. They said to rinse the water reservoir (I washed it out – again OCD)! Fill it back up with plain water. The “Fill” light will go out, the “K” will go on, run all of the water in this cycle through until the add water light comes on again.
5. Repeat Step 4 again (That’s two cycles of plain water).
6. When it is done, everything will shut off (unless you shorted the water, if it asks for more water, add more water to your reservoir, and finish it off). Then, when it’s done it should turn completely off. Hold your breath (very important!). When you turn it back on, the descale light should be off.
7. If the descale light is not off, one key I read is to unplug the machine, wait about a minute (I would make it two), then plug it back in again. Between my second and third times of descaling, I did this and moved the Keurig next to the sink (closer to the trash…). I don’t think that was the key, I think starting off hitting the correct ounce buttons when the machine was turned OFF, allowed it to go into “Descale” mode, because it operated completely different when that happened. I didn’t have to lift the lid up/down to press the “K” to get the water to come out, you just have to press the K and it only takes about 2-3 times for it to completely empty the reservoir. It’s a relatively fast process if you know what you’re doing! If none of that works, I would throw it in the trash and start over! Mine was an almost new Keurig and being so smart one day, I decided to clean out the k-cup area, and just try and be all sterile. That’s when the light came on. Lesson learned! I’m not sure the descale light ever came on with my previous one, I had it for years. It wasn’t until Hurricane Ian hit that I needed a new one, so slim trim pretty model. SMH! Go for reliable – LOL!
8. Which goes back to point #1, it would have been SO much easier if the instructions had been included in the descaling solution. After watching so many videos, the only other thing I learned is most people just use vinegar and save a few dollars. The reason for spending more for this product is it has less odor than vinegar. I used it twice in the process of the three cleanings, so a total of one bottle. Imagine a colonic for a Keurig! I’ve got the cleanest coffee machine in town.
Best of luck!

El producto es fácil de usar, excelente descalsifcador, de excelente calidad, llegó a tiempo, el precio lo considero justo, la atención del vendedor buena.

lo use para quitar sarro a cafetera

I hope it worked. It was easy to use.

I used this on my Keurig which would shut off constantly. It worked. The machine works again and coffee tastes SO much better! Will purchase again.

ya he comprado varias veces el producto ya que es necesario para mantener y prolongar la vida de la cafetera KEURING, llega a tiempo, y el precio lo considero justo.